Remove the old switch and replace it with the new one.According to, the average American family washes approximately 300 loads of laundry each year. Gain access to the top of the washer underneath the top cover and disconnect the power leads running to switch. If the switch is bad you can purchase a new one and then replace the faulty switch.īe sure that you unplug the washer from the outlet. You can also double-check and test the lid switch with a multimeter to see if there is continuity. You can open the lid, locate the lid switch and push down on the switch and listen for the telltale clicking sound. If you suspect the lid switch you test it in a couple of different ways. If you suspect that the lid switch maybe not working and therefore keeping the machine from working even though the lid is actually closed. This is to prevent anything from accidentally falling inside and causing damage. If the top lid is open the machine will stop running immediately and will not operate until the lid is closed again. The lid switch is an important part of the safety system that is builtin in all washing machines. Problem with the lid switch (Kenmore, Whirlpool, Maytag) If you find any debris, clear it all away and reattach the hose.īutton up the back access panel and plug the washer back in and check to see if it drains properly. Remove the access panel and locate the drain pump and remove the hose from the inlet side and check the filter for any debris that might be clogging it. So, the first thing you need to do is unplug the washer from the outlet and pull the washer away from the wall so that you can gain access to the back panel if the drain pump filter located behind the machine, but on the most of the front-loading machine filter located on the front. If you suspect a problem with the pump, you will need to gain access to the inside of the washer to check the pump filter. However, if during one of these draining cycles you hear that the pump appears to be running but water is either going down slow or not at all.Ĭhances are there might be a clog in the pump filter that is restricting or completely preventing the water from going through the pump. Try to run water through it and it does not come out the other end, you may need to find something long enough to shove down inside the clear the blockage.Ĭlogged drain pump filter (most common for Samsung, LG, Whirlpool, Bosch, etc)Īll washing machines have a water drain pump that is designed to evacuate the water from the tub after cycles of washing and rinsing the clothes. Once you have the hose completely disconnected check to see if there is anything lodged inside the hose. Once you have the hose disconnected from the machine you should remove it from the washtub or basin.
To check the hose of any clogs, be sure that you turn off the washer and move the washer so that you can gain access to where the drain hose connected to the washer. There could be a problem with the rubber hose that runs from the washing machine drain to the laundry room drain is clogged. If you are washing a load of close and you hear the drain pump kick on to start the draining process but nothing happens. The way this is usually accomplished is by using a water pump the sucks the water from the drum through the drain by using a hose.
Part of several of the cycles of the washing machine it is necessary for the water to be removed from the drum of the washing machine. 6 Most Common Causes For a Washing Machine Not to Drain Clogged drain hose
0 kommentar(er)
